Rvinfinitylights.com

General Information

All the custom created RV Infinity Light Medallion or multiple units are for ceilings or walls and made to order, there is no existing "stock". Lead time to build a custom unit or multiples varies depending on level of your customization. Typical build time is 4-6 weeks or less.

The most ordered size is 23" wide by 53" long because it is easy to ship by FedEx or UPS with their packaging and insurance to protect your investment. Some customers install 2 units in the lounge and one in the bedroom. Bedroom medallions are typically non-infinity to contrast the Lounge units but use color mirrors.

The medallions are built with a factory VaccuBond lamination process, CNC cut frames, rings and mirrors. All parts and sub-assemblies are new with manufacturers warranty. Each medallion comes with custom Radio Frequency remote controls for both Infinity perimeter and inside detail as well as a separate remote with 2 channels for the LED  Warm White cove lighting.

The installation is straight forward once you have located the rafters in your ceiling that run normally 16" on center in most units. The Controllers for the LEDs are Radio Frequency command and do NOT need line of sight.

These are the same medallions that I have built and are being advertised through  another channel by Factory RV Surplus in Elkhart IN as Gen 1 medallions wrapped in different colors Ultraleather.

Since then I have developed Gen 2- Wrapped in White or black laminate factory process  - most of the pictures on this site that show medallions with LED puck lights for general illumination.

Recently I have released the frame-less Gen 3 Medallions that you see on the main page. They are absolutely gorgeous. Unfortunately they can not be built with puck lights and are reserved for applications where they are accent pieces and the general illumination of the area is done in other ways such as the available 3 puck light fixtures that replace the conventional outdated Fluorescent 2 tube lights.

RV Infinity Light Medallion

 - The ultimate RV aftermarket luxury - reserved until now for  million dollar coaches - custom mirrors with programmable lights for your ceiling - Turn that bland looking ceiling of your coach into art - be the envy of all your friends

- A superb ceiling mirror that creates the feeling of open air and tall ceilings inside during the day with lights off and a superb art piece at night when you turn the lights on - Looks like you installed Cathedral Ceilings on your coach

- Only 2in. thick - LEDs are good for 30,000 hrs- or 1" thick for the frameless unit

- 3 way lights controlled independently by switch and RF remote controls without interference - Draws only 6-9 amps with all the LED lights on - designed for 12-14.5 V Negative Ground systems.

-  LED puck lights, dimmable cove Warm White LED lighting close to ceiling and mesmerizing colorful RGB "Infinity Art" effect inside the mirror with custom colors and light motion effects including Fade, Jump, Flicker and Strobe patterns.  

- Replaces a regular 12v ceiling recessed light in any motor home, 5th wheel, travel trailer - LED controllers can be moved a few inches either way to accommodate  placement inside the cavity where the recesses body of the light body came from for a factory look, flush  ceiling installation

- Lightweight , not made of glass - weighs around 30 lbs for a 55x23 inch model - quote required for custom sizes - Professional installation suggested but it is up to your skill level

- Mounts to the ceiling by locating the 16 in ( or other) center-to-center cross member studs (wood or Aluminum) and securing the medallion upwards into the studs with capped color coordinated screws- does not come pre-drilled to allow for custom mounting applications - your imagination is the limit

Website Builder